AP-17.01

**Double Immelmann with roll, roll**

From upright, pull through a ½ loop, perform a roll into inverted flight, pull through a ½ loop, perform a roll, exit upright.

AP-17.02

**Figure M with ¼ roll, ¼ roll**

From upright, pull through a ¼ loop into a vertical up line, perform a ¼ rolls, perform a stall turn into vertical downline, push through a ½ loop into a vertical up line, perform a stall turn into a vertical downline, perform a ¼ roll, push through ¼ loop, exit inverted.

AP-17.03

**Horizontal Circle 8 with two rolls**

From inverted perform a ¼ horizontal circle while performing the first ¼ of consecutive two rolls to the outside, then while continuing the rolling (¼ of the rolls per ¼ of the circles), perform immediately another (full) circle in the opposite direction, then, while continuing the rolling accordingly finish the remaining ¾ of the first circle, exit inverted.

AP-17.04

**½ Horizontal Square Circle with two ¼ rolls**

From inverted, perform a ¼ horizontal circle with wings level, perform consecutively two ¼ rolls, perform a ¼ horizontal circle with wings level, exit upright.

AP-17.05

**Roll Combination with consecutive 1 ¼ roll, 1 ¼ roll**

From upright, perform consecutively a 1 ¼ roll and a 1 ¼ roll in opposite directions, exit

upright.

AP-17.06

**Knife-Edge Humpty-Bump with two consecutive ½ rolls, ½ roll**

From upright, pull through a ¼ loop into a vertical up line, perform consecutively two ½ rolls in opposite direction, perform a ½ knife-edge loop into vertical downline, perform a ½ roll, push through a ¼ loop, exit inverted.

AP-17.07

**Knife-Edge Cobra Roll with ¾ roll, ¾ roll**

From inverted, push through a 1/8 loop into a 45° up line, perform a ¾ roll, perform a ¼ knife-edge loop into a 45° downline, perform a ¾ roll, pull through 1/8 loop, exit upright.

AP-17.08

**½ Horizontal Circle with four consecutive ¼ rolls**

From upright, perform a ½ horizontal circle while integrating consecutively four ¼ rolls, exit upright.

AP-17.09

**Vertical Up line with consecutive two ½ torque rolls**

From upright, pull through a ¼ loop into a vertical up line, reduce flying speed to zero in the middle of that line, perform in this position consecutively two ½ torque rolls in opposite directions, then accelerate, push through a ¼ loop, exit upright.

AP-17.10

**½ Square Loop with consecutive two ¼ rolls**

From upright, push through a ¼ loop into a vertical downline, perform consecutively two ¼ rolls pull through a ¼ loop, exit upright.

AP-17.11

**Knife-Edge Loop with ¼ roll, ½ roll, ¼ roll**

From upright, perform ¼ roll, perform a knife-edge loop with a ½ roll integrated in the top 90°, perform a ¼ roll, exit upright.